Here are four methods to do the job right.
Framing for board and batten siding.
Writing to fine homebuilding s breaktime forum wenws is looking for some advice on the best way to finish the board and batten siding for his new house.
How to do it prep walls.
There are no collection board or batten widths.
Battens which he says he ll finish with a high quality stain.
Today board and batten siding is kiln dried to reduce warping and it s installed over framing sheathing and a vapor barrier to lend greater structural integrity.
Board and batten is a siding and paneling style that uses narrow strips of wood placed over the joints of wide boards for a geometric layered effect.
His plans call for 9 1 2 in.
Board and also batten siding is a vertical layout developed making use of large boards spaced apart with narrower boards battens that cover the joints.
Upper layer battens and corner boards are the final touches.
Historically and traditionally a wooden batten would be placed over a seam between the wide boards creating a stronger and more energy efficient siding.
Install overlying battens typically 2 to 4 battens cover the gaps between the boards and hold the edges of.
Install water table boards.
Nail it up and let er dry on the wall.
Below the window cut a bit of an angle on the top edge of the batten so that it does not protrude and catch water.
On 12 wide boards put two nails about 3 inches apart in the middle and make sure the nail for the batten goes between the boards.
Prepare the walls as you would for other wood sidings by applying building wrap self stick flashings at the.
On each wall measure.
Corner boards are generally around 4 5 wide and are glued and screwed.
For 12 wide use no less than 2 inch battens.
In the photo you see the sticker stain from green stickers on green wood that was allowed to be rained on before installation.
There are many ways to nail board and batten siding.
Different combinations could be made use of to create various appearances.
All around the house install a 1x6 or wider water table with its bottom edge 2 inches below.